Pickett Model N600-ES Log Log Speed Rule
Engineering; Mechanical Engineering; Mathematics
Physical Description:
The Pickett Model N600-ES Log Log slide rule is constructed using three yellow painted aluminum bars. The “ES” in the model name means “Eye-Saver” and refers to the yellow painted construction. The two outer bars are called the stators and are attached by a brace on both ends. The braces create a gap between the two stators where the third aluminum bar, called the slide, fits into the grooves between the two stators. A clear plastic cursor slides along the outside of the stators. The cursor has a vertical hairline marker on both sides of the slide rule for lining up the scales between the slide and stators. The upper stator has LL1 and A scales on the front side and LL2 and DF scales on the backside. The lower stator has D, DI, and K scales on the front side and D and LL3 scales on the backside. The slide has B, ST, T, S, and C scales on the front side and CF, Ln, L, CI, and C scales on the backside. The scales are usually logarithmic with a few exceptions such as the L and Ln scale which are log operations with a linear scale. The index of a scale is the furthest left number for the left index or the furthest right number for the right index. The scale ranges and operations are described under inscriptions.
Functional Description:
The Pickett Model N600-ES Log Log slide rule is a duplex slide rule. A duplex slide rule has scales on both sides of the slide rule and a dual-faced cursor. The dual-faced cursor allows for relating one side of the scale to the other side for a greater number of calculations. Logarithmic scales have a multiplication and division property discovered by William Oughtred in 1630 that allow for the operations of multiplication and division instead of addition and subtraction of linear scales. Multiplication is the simplest operation on a slide rule using the two fundamental scales, C and D. To multiply two numbers, x and y, the left index of C is positioned over x on the D scale. Then the cursor is position over y on the C scale. The value of the cursor on the D scale is the solution to x multiplied by y. The decimal place may need to be adjusted to get the correct order of magnitude since the C and D scale has values ranging from 1 to 10. The other scales are used to perform different operations such as squares, reciprocals, exponentials, and sines, cosines, and tangents.
Gideon Hoekstra, Nick Renke, Donovan Doran, Erik Madson
1962
English